Proxicast Active/Passive SMA GPS Antenna - Through Hole Mount - 6 ft Coax | Panel Mount GPS Antenna SMA Male Connector (Right Angle) Low-Loss - 28 dB($24.95Value)

Description

LOW PROFILE GPS PUCK ANTENNA for Devices with External GPS Antenna Connectors NARROWBAND L1 FILTER (1575.42 ± 1MHz Center Frequency) Improves GPS Reception (Signal-to-Noise Ratio) and Positional Accuracy PERMANENT MOUNT - Through Hole Screw Mount Design for Vandal Resistant Mounting - No Exposed Cable SMA MALE CONNECTOR on 6 ft (2.0 m) of Low Loss Cable - Works with Standard GPS Receiver Outputs LOW NOISE AMPLIFIER - Boosts GPS Signal - 28 ± 4.5dB Gain - Compatible with 3~5V DC GPS Receivers (Passive Gain: 5 dBic Zenith) Proxicast's low-profile active GPS antenna is designed for use in fleet management, automatic vehicle location (AVL), mobile robot tracking, mobile video, positioning, timing and recreational navigation applications that require peak gain in a compact, vandal resistant form factor. It is ideally suited for positioning and timing systems in vehicular GPS-enabled modems/routers and dedicated GPS receivers. The external GPS antenna can be used with passive or active GPS equipment via its integrated 28 dB LNA and noise rejection filter.

The GPS active antenna permanently mounts via a 1/2 in (12 mm) hole with internal nut and includes 6 ft of low-loss RG174 coax fed through center mounting post pre-terminated with a right-angle standard SMA Male connector. A rubber boot creates a water-tight seal. The short GPS antenna is not removable from outside and there is no exposed coax cable once installed.

Electrical Specifications
• Center Frequency: 1575.42 MHz
• Passive Gain: 2dBic
• LNA Gain: 28 ±4.5dB Typical
• Polarization: RHCP
• LNA Supply Voltage: 3-5.0 VDC
• Current Consumption: 13~22 mA
• V.S.W.R: <2
• Impedance: 50Ω
• Noise Figure: < 1.5
• Axial Ratio: 3dB（max)
• Ex-Band Attenuation: 20dB@CF+50MHz

Mechanical Specifications
• Cable: 6.6 ft (2.0 m) RG174
• Connector: SMA Male
• Material: ABS / Brass / Steel / Copper / Rubber
• Mounting: 0.5 in (12 mm) hole - nut & rubber boot included
• Ingress Protection: IP67 waterproof when mounted
• Operating Temp.: -30 to +80C
• Dimensions: 2 x 0.75 in (50 x 19 mm) when mounted
• Weight: 3 oz (85 g)