S&F STEAD & FAST Digital Angle Finder Magnetic with Case & Backlit LCD | Self-inverting display, ±0.2° accuracy, Absolute & Relative, Hold & Zero,($28.25Value)

Description

PRECISION YOU CAN TRUST — Dial in table saw blades, miter cuts, and camber angles to within ±0.2°. Zero device to reset if necessary. Switch instantly between absolute and relative angle modes, degrees and slope percentage modes. READ IT ANYWHERE — Bright on-demand backlit LCD plus auto-inverting display gives you a clear readout under saw tables, in dim shop corners, or with the table saw angle gauge flipped upside down LOCKS ON, STAYS PUT — Strong rare-earth magnetic base grips circular saws, blades, miter saws, and any ferrous surface. 4-sided magnetic angle finder also available in our store. Hold function freezes the reading so you can move the tool without losing the angle. SHOP-TOUGH BUILD — Tough aluminum frame, works from 32°F to 122°F (0°C-50°C). Auto-off and low-battery warning save power. Battery case is secured with screws for IP54 dust/splash resistance. Angle finders without screws are available in our store. READY OUT OF THE BOX — Factory-calibrated, includes protective fabric case, 2× AAA batteries (up to 120 hours runtime), precision screwdriver, and step-by-step manual. PRODUCT OVERVIEW

The S&F Level Box Angle Finder is compact and highly convenient for measuring absolute and relative angles.

Rated IP 54, the angle locator is resistant to splashing water and dust ingress.

The angle finder / degree finder has so many uses, it is a must-have for both the hobbyist and professional. Applications include the following:

• Setting up your table saw, mitre saw, band saw, circular saw at the right angle
• Checking the angle of your solar panel
• Working on camber alignment
• Knife sharpening guide requirements
• Measuring roof pitch
• Ensuring a plane is perfectly level (paintings, floors etc.)

The angle finder / angle block is supplied already calibrated but recalibration is easy if necessary. Follow the instructions on the manual.

The inclinometer is supplied with a jewelry screw driver to remove the small screws at the back. You may wish to secure the screws to the magnetic base of the angle finder while installing and replacing the batteries.

SPECIFICATIONS

• Measuring range: 4 x 90°
• Resolution: 0.05°
• Accuracy: ±0.2°
• Working temperature: 0℃ – 50℃, 32℉ - 122℉
• Automatic power off after 3 minutes
• Product size: 57 x 55 x 26 mm

OUR COMMITMENT

We stand by the quality of our products. Should any of them be defective, you will have the choice of a refund or a replacement.