Refrigeration Fan Motor, Energy Efficient, 1/12hp, 1550 RPM, 115 volts. Fasco # 9721 by Fasco | 3.3 frame, 3-5/16 in body, 2-13/16 in bolt circle, 5/($79.99Value)

Description

Refrigeration fan motor rated 1/12 HP with a 1550/1350 RPM nameplate speed, one speed, permanent split capacitor design running on 115 or 208-230 volt single phase 60 Hz supply Check these five before ordering: 3.3 frame, 3-5/16 in body diameter, 2-13/16 in bolt circle, 5/16 in shaft diameter with 3-1/4 in extension, and a 2 in by 2 in four stud pattern A 4 microfarad 370 VAC run capacitor is required and is not included, so order one separately. Extra mounting nuts and a reversing plug are packed with it as well Rotation is published both clockwise and counterclockwise with a reversing plug supplied, but no reference end is stated, so match the airflow you remove. Amps are listed as 1.1 and 0.49 Open air over steel frame, ball bearings at both ends, ring and stud mounting with four studs on each end, Class B insulation, 40 C ambient, for refrigeration evaporator fan duty The Fasco 9721 is a 3.3 inch frame refrigeration fan motor rated 1/12 HP with a nameplate speed of 1550/1350 RPM, one speed, on either 115 volt or 208-230 volt single phase supply. It is a permanent split capacitor design and is catalogued as a multi horsepower replacement covering 1/12, 1/15 and 1/20 HP permanent split capacitor and shaded pole evaporator fan motors used in walk in cooler, freezer and refrigerated case equipment. Body diameter is 3-5/16 inches, the bolt circle is 2-13/16 inches, and the stud mounting pattern is 2 inches by 2 inches with four studs at both ends. Shaft diameter is 5/16 inch with a 3-1/4 inch extension. Published data describes the shaft form inconsistently, listing it as both flat and keyed, so check the fan hub bore and set screw arrangement before ordering. A 4 microfarad 370 VAC run capacitor is required and is not included with this motor. Extra mounting nuts and a reversing plug are supplied that lets you set direction at installation. Rotation is listed as clockwise and counterclockwise with no reference end published, so match the airflow of the motor you remove. Bearings are ball type at both ends, insulation is Class B, maximum ambient is 40 degrees C and thermal protection is automatic. Full load current is published as 1.1 and 0.49 amps, weight is 5 pounds and lead length is 21 inches.