JJC Wireless Remote Control for Panasonic Lumix G9 II G85 G7 GH7 GH6 GH5 GH5S GH4 S5 S1 S1R S1H GX8 GX7 FZ2500 FZ2000 FZ1000 II FZ300 FZ100 FZ150($29.99Value)

Description

16 possible radio channels, Operate on Radio Frequency 433 MHz, 1 transmitter can trigger multiple receivers Up to 30 meters range Can trigger cameras wireless or wired Can wirelessly trigger the camera shutter under 5 modes: single shot, unlimited continuous shots, bulb shot, 3 continuous shots and 5 seconds delay shot. (Note: It's not able to control video start and stop) For Panasonic DMC-FZ2500,FZ2000,FZ1000,FZ1000 II,FZ300,FZ100,FZ150,FZ200,FZ20,FZ30,FZ50,S1,S1R,S1H,S5,G1,G2,G3,G5,G6,G7,G9,G85,GF1,GH1,GH2,GH3,GH4,GH5,GH5S,GH6,GH7,GX7,GX8,G9 II, Replaces Panasonic DMW-RS1/DMW-RSL1 Remote This Wireless Remote is designed for cameras that has a remote shutter socket. The system works at a 433MHZ frequency and has 16 available channels. In addition, this wireless remote system adopts a technology to allow the transmitter trigger the receiver without direct line of sight up to 30 meters. The transmitter can trigger the camera shutter at five modes: single shot, 5 seconds delay shot, 3 continuous shots, unlimited continuous shots and bulb shot/bulb lock.

Compatible with Panasonic cameras:

DMC-G1,DMC-G10,DMC-G2,DMC-G3,DMC-G5,DMC-G6,DMC-G7,DC-G9,DMC-G85,DMC-GF1,DMC-GH1,DMC-GH2,DMC-GH3,DMC-GH4,DC-GH5,DC-GH5S,DMC-GX7,DMC-GX8,L1,L-10,LC-1
DC-S1,DC-S1R,DC-S1H,DC-S5
DC-FZ2500,DC-FZ2000,DC-FZ1000 II,DC-FZ1000,DMC-FZ300,DMC-FZ100,DMC-FZ150,DMC-FZ20,DMC-FZ200,DMC-FZ20K,DMC-FZ20S,DMC-FZ30,DMC-FZ30K,DMC-FZ30S,DMC-FZ50,DMC-FZ50K,DMC-FZ50S

Compatible with Leica cameras:

DIGILUX3,DIGILUX2,V-LUX1,V-LUX2

Important - How to use:

1. Install the CR-2 battery to the receiver and 23A battery to the transmitter. (Make sure to remove the plastic protective paper on the battery before installation)
2. Set the receiver and transmitter to the same channel (Normally the channel is already matched when you receive the package, so actually you don't need to set it, but if you ever reset the channel, make sure they are the same)
3. Once the batteries are properly installed and the channels are matched, when you press the shutter button on the transmitter, both the LED bulb on the transmitter and receiver will light up. (If not, please check if the battery is installed correctly or the battery is dead)
4. Once the transmitter matches the receiver, connect the receiver to the camera via the camera connecting cable which is included in the package, then set the transmitter into the working mode you want and finally press the shutter button to take a photo wirelessly.